Werksverlagerung

– Geotechnical study
– Technical Documentation for the Building Authorization (D.T.A.C.)
– Technical Design and Building Details (P. Th. + D. E.)

Authorizations are those needed from the local suppliers of utilities: electrical energy, water, sewerage, thermal energy, natural gas, telephony, sanitation, urban transport etc., specified through the Certificate of Urbanism.

The building work began as soon as the Building Authorization was obtained and the local mayoralty and the Inspectorate of State for Buildings have been notified.

By hiring a building site master the performance of work has been followed up and the technical book of the building has been issued. During the building work the specialty designer has followed up the achievement of the building work by determining stages, as specified through the Quality Control Program that belongs to the approved documentation.

– Roof refurbishment
– Inner lighting of the foundry hall
– Reconditioning the polycarbonate skylights
– Electric supply for the roof fans
– Building the trays needed for the electrical cabinets/panels
– Constructions needed for closing the foundry hall
– Perimeter closings and compartments
– Metallic chimneys for ventilation and dust filter
– Heating installations for the foundry hall
– Metallic silo for regenerated sand
– Metallic silo for broken mixture
– Constructions related to the furnace emergency tank
– Foundations for filters, breaker, furnaces, mixers and pneumatic conveyor.

– Foundations and constructions related to the induction furnaces of 20 tons and 25 tons
– Electrical and ventilation trays for the front side and rear side of the furnace
– Pneumatic transport
– Compressor stations and inner main lines of compressed air
– Ventilation installation for the melting – dust removal furnaces and transformer room
– Dust removal installation related to breaking
– Electricity supply, from the power supply panels, of the foundry equipment
– Electricity supply of the power panels
– Electric installations for the control room and the ventilation of the furnace transformer enclosure.
– Constructions related to the casting pits
– Breaker foundation
– Foundation and bunkers for the 10t/h mixer
– Foundation and bunkers for the 60t/h mixer
– Foundation and new sand bunker
– Foundations for the regenerated sand silos, broken mixture and new sand unloading
– Foundation and constructions related to the regeneration installation

– 20kV outer electric networks
– Electric supply of the compressor station
– Outer water and sewerage networks related to the users
– Layouts of foundations and floors at the zero elevation
– Constructions related the cooling installations of the induction furnaces
– Dust removal installation for the sand regeneration station
– Installation + suction hood for core painting
– Breaker cabin
– Hydro-technical groove
– Room arrangement for sandblasting
– Electricity supply of overhead cranes
– Protection and signaling for the furnace transformer station
– Inner installations for natural gas, grinding, sandblasting and others.

The final acceptance of the work was settled through an Acceptance Protocol, signed in 2009.

This has been drawn out by a board composed of:
– Representative of the Inspectorate of State for Constructions
-Representative of the local mayoralty or the County Council
– Architect and builder of the load structure.
– Representative of the customer – building site master.